Installation guide

122 Advisor Master Programming Guide
Defaults
The only events activating an output by default are:
• Output 2 (strobe output) is linked to event flag 2.
• Output 16 (panel siren output) is linked to event flag 1.
• Output 15 (internal siren output) is linked to event flag 13.
• Output 32, 48, 64, 80, 96, 112, 128, 144, 160, 176, 192, 208 224, 240 (DGP
siren outputs) are linked to event flag 1.
For more information on event flags, see “Event Flags” on page 177.
Timezone to control output
Output 3 Timezone 12
Timezone No:
The timezone entered controls the times that an output is active or inactive. If a
timezone is programmed, it sets the output when the time is valid. The status of
the event flag is irrelevant when the timezone is valid. If the timezone is invalid,
the output follows the event flag. If no timezone is programmed the output follows
only the event flag.
See also “13-Timezones” on page 111.
Active or inactive during timezone
Output 3 Inactive During Timezone
*-Change
Determine the effect if the timezone is valid.
Active: If set to Activate during timezone, the output activates when the timezone
is valid regardless of the status of the event flag and provided the output is not
inverted.
Inactive: If set to Inactive during timezone, the output does not activate when the
timezone is valid regardless of the status of the event flag and provided the
output is not inverted. If the timezone is invalid, the output follows the event flag.
Invert output
Output 3 is NON-Inverted
*-Change
Inverted: If the output is inverted, the logic controlling the output is reversed. E.g.
if the previous logic determines that the output is to be ON, this setting would
change it to OFF.
Non-inverted: The output follows the event flag. If the event flag is active, the
output is ON.