Installation guide

128 Advisor Master Programming Guide
20-System codes
The ATS control panels support up to two different system codes (sometimes
also referred to as "Site codes" or "Facility codes") for use with ATS1170 one-
door RAS. Each system code also provides an option to offset the card ID for
easier programming. The system code is a unique code provided by the supplier.
Notes
• The ATS125x/1260 four-door/four-lift DGP does not require this setting to be
programmed in the control panel. Using the menu “28-To remote devices” on
page 138 it is programmed in the DGP. Also see the programming guide of
the ATS125x/1260.
• In IUM mode these values should be set to 0.
System code settings
System code 1
System Code 1: 004346
SysCode:
Enter the first system code here. The system code is provided by the supplier
and is unique to the reader device and card range
The system code normally has 6 digits. If less then 6 digits are provided, add
leading zeroes.
Card offset 1
Card Offset 1: + 0
*-Chg, No:
Specify the number to be added or subtracted from the actual card ID number,
for cards in System Code A. The ATS control panel will calculate the user
number from:
User Number = CARD ID + (or −) card offset
The calculated user number is used for programming the user and when
reporting events to the central station or the computer.
For example: The card offset is programmed as −5000. The actual physical card
ID number is 5001. The card will be programmed as User 1, and will report as
User 1.
How to program
Press one of these keypad buttons to:
• Menu: Change the offset to + (add) or − (subtract).
• ?, Enter: Enter the card offset required.
• Enter: Save the displayed setting and move to the next display.