Installation guide

138 Advisor Master Programming Guide
28-To remote devices
Use this option to access the programming menus for 1-Door RASs (e.g.
ATS1270) or four-door/four-lift DGPs (e.g. ATS1250/1260). These remote
devices have additional menu’s that can be accessed via the control panel using
this menu.
The remote device has to be:
• Connected to the ATS system databus
• Addressed as a RAS or DGP with on-board DIP switches
• Programmed to be polled in the menu “3-RAS database” (page 39, RASs
only) or “4-DGP database” (page 48, DGPs only)
• Programmed with the correct type (DGPs only) in menu “4-DGP database” on
page 48.
Select the device type
Remote Device: 1-DGP 2-RAS
Device:
To establish a connection to the remote device, select the device type first. The
type is either a RAS (for example, ATS1170 or ATS1192) or a DGP (for example,
ATS125x/1260 or ATS1201E).
Select the device to program
Select the device number to program. The number is the same number as set
using the DIP switches on the device.
For further information on programming the remote device, see the programming
guide for the device.