Installation guide

140 Advisor Master Programming Guide
Up/download if any area armed
No–Up/Download if any Area Armed
*-Change 0-Skip
Note: Option 29.1 must be set to Yes to use this option.
Specifies if connecting via dialler to a remote computer is possible if any area is
armed. If set to No and a remote connection is established, the panel will be
disconnected when the user arms the system.
Yes: A remote connection is possible if an area is armed.
No: A remote connection is not possible if any area is armed.
Press 0 to go directly to menu 29.8
Enable remote control
No–Enable Remote Control
*-Change 0-Skip
Specifies if arming areas, controlling outputs and door control is allowed from a
remote computer via dialler.
Yes: Remote arming of areas, controlling outputs and door control is allowed,
when disarmed.
No: Remote arming of areas, controlling outputs and door control is not allowed,
when disarmed.
Press 0 to go directly to menu 29.8
Note: This option will only disable remote control function and not status
requests, and will only operate if 29.1 is set to Yes, and also depends on option
29.2 and the status of the areas.
Remote control if any area armed
No–Remote Control if any Area Armed
*-Change 0-Skip
Note: Option 29.1 must be set to Yes to use this option.
Specifies if disarming and arming areas, controlling outputs and door control is
allowed from a remote computer via dialler.
Yes: Remote disarming and arming of areas, controlling outputs and door control
is allowed.
No: Remote disarming and arming of areas, controlling outputs and door control
is not allowed.
Press 0 to go directly to menu 29.8