Installation guide

Advisor Master Programming Guide 9
Zone type
Description
8.
Dis. delay/Arm Gen. Alm
Generates an alarm when the area is disarmed but does not
report it to the central station until the delayed alarm timer has
expired or a second delayed alarm is activated.
Generates a general burglar alarm when the area is armed.
Example: Hold-up button on a counter where more than one
hold-up button is used.
You need to program the Disarmed Alarm Delay Time. See
“6-Timers” on page 62 for more information.
9.
Reset Delayed Zones
Resets a delayed alarm type if the zone switches to normal
state.
Resets a delayed alarm type if the delay timer is still running
(therefore a full alarm has not been activated).
Stops cameras from operating if the zone is activated, but the
delayed time continues to run.
Example: Reset button for quick cancellation of alarm.
Delayed zone types are: 8, 11, 22, and 40.
10.
Do not use
11.
Dis. Delay Alarm
Generates an alarm when the area is disarmed but does not
report it until the delayed alarm timer has expired or a second
delayed alarm is activated.
Generates no alarm if the area is armed.
Example: Hold-up button.
You need to program the Delayed Alarm Time. See “6-
Timers” on page 62 for more information.
12.
Restart Exit Timer
A pulsed keyswitch that resets the entry timers and restarts
the exit timers for all areas assigned to the zone.
Example: Keyswitch next to door.
You need to program the correct area(s).
13.
Entry/Exit No Arm
Check
Generates no alarm when the area is disarmed.
When the area is armed, the exit timer starts and activating
the zone will generate no alarm. If the zone is activated and
the exit time has expired, the entry timer starts. When the exit
time has expired, an alarm will be generated.
The zone may be activated when arming the area.
Example: Contact on frontdoor.
You need to program the Entry Exit Time. See “2-Area
database” on page 28 for more information.
14.
Access No Arm Check
Generates no alarm when the area is disarmed.
Generates an alarm when the area is armed and no entry/exit
timer for the area is active.
The zone may be activated when arming the area.
Example: PIR in hallway.
You need to program the Entry Exit Time. See “2-Area
database” on page 28 for more information.