Installation guide

Advisor Master Programming Guide 145
30-Printer
Program the details for the printer. To obtain a printer output from the ATS
control panel, a serial printer interface (ATS1802) or serial computer and printer
interface (ATS1801) has to be fitted.
Printer settings
Enable real-time printer
NO-Enable Real Time Printer
*-Change 0-Skip
Enables the printer output to print in real-time.
Yes: Enable the printer port on the ATS control panel to print each event as it
happens. "Print History" can still be used, if required (see manager guide).
No: A printer is not connected or you do not require the printer to run in real time.
"Print History" must be used to obtain a print-out.
Press 0 to leave Printer menu.
Note: Before anything will be printed real-time, either “Print alarm events” below”
above or “Print access control events” below have to be set to Yes.
Print alarm events
No –Print Alarm Events
*-Change 0-Skip
Prints all alarm events.
Yes: All alarm events are printed.
No: Alarm events are not printed.
Press 0 to leave Printer menu.
Note: Before anything will be printed real-time, either “Print alarm events” above”
or “Print access control events” below have to be set to Yes.
Print access control events
No –Print Access Control Events
*-Change 0-Skip
This function prints all access control events.
Yes: All access control events are printed.
No: Access control events are not printed.
Press 0 to leave Printer menu.
Note: Before anything will be printed real-time, either “Print alarm events” above”
above or “Print access control events” have to be set to Yes.