Installation guide

Advisor Master Programming Guide 167
52-Voice reporting
BA Burglar Alarm – Voice Message 0
Msg. No.
Reporting code no.
Program the voice messages to be transmitted to the monitoring station, if voice
protocol is programmed. See “9-Communication options” on page 94.
Voice Messages can be programmed to report on the following alarm events.
More than 1 event may have the same voice message programmed. Range is
from 0 to 14.
Table 11: Default table
Reporting Code No.
Reporting Code
Voice Alarm Message
1
Burglar Alarm
Default 0 = No message assigned
2
Tamper Alarm
3
Hold-up Alarm
4
Panic Alarm
5
Fire Alarm
6
Medical Alarm
7
Technical Alarm
8
Mains Fail
9
DGP Offline
10
Area Disarmed
11
Area Armed
As well as the above, the user can also program alarm messages to the following
event codes, allowing for greater flexibility as required. Macros can then be used
to trigger these event codes from various sources.
E.g. an input can be programmed to report to event code 131 BA Perimeter. The
input can then be triggered using macros etc.
Table 12: User table
Reporting code No.
Reporting code
Voice alarm message
12
130 BA Burglary
13
131 BA Perimeter
14
132 BA Interior
15
133 BA 24 Hour
16
134 BA Entry/Exit
17
135 BA Day/Night