Installation guide

Advisor Master Programming Guide 169
53-Program DVMRe
Note: This is a legacy option. Current DVR/NVR firmware no longer supports
RS232 commands.
DVMRe alarm handling via the printer port
In a conventional alarm-handling configuration the alarm devices are connected
via the alarm PCB on the back of the DVMRe unit. Each alarm input corresponds
with the camera input of the same function.
Alarm input to camera assignments can be changed on 10 and 16-channel
models via the DVMRe programming.
On an input trigger, the internal buzzer will be activated and an on-screen alarm
display will be activated.
Macros can be programmed to achieve full CCTV scenarios.
Many different options are possible depending on the programming of the
DVMRe.
An additional feature, which can be combined with external an alarm triggering, is
a text insertion to the triggered alarm frame.
The ATS printer interface connection to the DVMRe provides all in one.
DVMRe alarm input map
DVMRe Alarm Input Map
Alarm Input:
“*”- Next, DVMRe Alarm Input 1 No relay
Relay:
This menu controls the setting to trigger an alarm input from the DVMRe by
programming an output of the ATS panel. In total 16 DVMRe alarm inputs can be
linked to an ATS output. All 255 ATS outputs can be programmed.
Setting or un-setting an ATS output triggers a DVMRe alarm input. ATS outputs
are used rather than event flags because outputs can be activated via time zones
as well.
The DVMRe can be programmed to execute a macro linked to a DVMRe input.
High Level Interface (HLI) control flags
Enable DVMRe interface
YES-Enable DVMRe Interface
*-Change 0-Skip
Enables the High Level Integration between the ATS panel and the DVMRe.