Installation guide

170 Advisor Master Programming Guide
Yes: The ATS panel and DVMRe connection can be established and the next
following control flags will be considered.
No: Overrides all other control flags and there will be no communication at all
between the ATS panel and the DVMRe.
Note: If the DVMRe HLI is used, the ATS panel will no longer be able to
communicate with a serial printer.
Enable time update
YES-Enable Time Update
*-Change 0-Skip
This feature will ensure that the time and date of the DVMR are synchronised
approximately every 60 seconds with the ATS panel. When performing video
history searches the time and date will be based upon the occurrence of ATS
panel events.
Yes: The ATS panel time and date will be synchronised to the DVMRe.
No: No time and date synchronisation will take place.
Enable event text insertion
YES-Enable Text Insertion
*-Change 0-Skip
This option automatically inserts event text from the ATS panel (printer output)
into camera 1 text box of the DVMRe. This text will be associated with the
footage recorded to all cameras with that time stamp.
Yes: The ATS panel will insert the event text to the DVMRe text box.
No: No event text insertion will take place.
Enable alarm feedback
YES-Enable Alarm Feedback
*-Change 0-Skip
The DVMR has the facility to issue user programmable strings on the occurrence
of user definable alarm conditions and motion detection. The strings will be sent
out via the HLI and received by the ATS panel. Based upon the content of the
received strings after processing, the ATS panel can manipulate zone inputs
allowing alarm reporting and control of various types to be performed.
Yes: The DVMRe will send out the user programmable strings on the occurrence
of pre-defined alarm condition.
No: No alarm condition strings will be send out.