Installation guide

Advisor Master Programming Guide 201
Additional functions
The following settings are default. Modifying these settings has no influence on
EN 50131 compliance.
• “Film low level” on page 70: 800
• “Film out level” on page 71: 1100
• “No. of output controllers” on page 71: 0
• “Zone event text” en page 72: 0000
• “Alarm code prefix” en page 72: 0
• “LCD rotation delay” on page 72: 0
• “LCD rotation speed” on page 72: 0
• “Display one zone at a time” on page 73: Yes
• “Username file” on page 74: Yes
• “Siren testing” on page 75: No
• “Disable "0, ENTER" for camera reset” on page 75: Yes
• “Disable insert of AG restriction” on page 75: No
• “Disable flashing area LEDs” on page 76: No
• “Two users before programming code” on page 76: No
• “Display alarms instantly on LCD” on page 76: Yes
• “Financial options” on page 77: No
• “Display user flags” on page 77: No
• “Delayed disarmed alarm lockout” on page 78: No
• “Zone expansion fitted” on page 78: No
• “Engineer reset for system alarms” on page 79: No
• “Engineer reset for system tampers” on page 80: Yes
• “User offset” on page 81: 0
• “Soak test days” on page 83: 7
• “Enable "Call Central Station" display” on page 84: Yes
• “Synchronize DGP users records” on page 88: Yes
• “Engineer reset on RAS lockout” on page 88: No
• “Override AC mains fail” on page 89: Yes
• “Override battery fault” on page 90: Yes
• “Override signalling fault” on page 90: Yes
• “Override siren fail” on page 90: Yes
• “Override detector trouble” on page 90: Yes
• “Override RAS fault” on page 91: Yes
• “Override DGP fault” on page 91: Yes
The installer (user level 3) commissions the system with appropriate additional
functions.
The end-user (user level 2) is able to make use of all these functions.
The Installer can only make use of these functions when he has an access
granted by end-user.