Installation guide

212 Advisor Master Programming Guide
enable ISDN line fault monitor, 95
enable log limitations, 85
enable soak test, 19
end-of-line resistors, 73
engineer entry protect, 80
engineer reset, 85, 86, 88, 166
system alarms, 79
system tampers, 80
zone alarm, 19
zone tamper, 18
engineer reset on ACPO zone B alarm, 83
engineer walk test, 26
engineering reset, 80
entry/exit
buzzer on RAS, 44
delay reporting, 66
program time, 28, 29
shunted entry/exit zone, 133
errors between ATS and units connected
number detected, 135
event flags
24 hr alarm 8, 24
activated by zones, 22
active, 30
all areas armed, 153
area disarmed, 29
armed alarm, 24, 30
armed alarm 10, 24
armed alarm 11, 25
armed alarm 9, 24
camera, 25, 31
chime, 25, 31
code tamper, 46
DGP isolated, 152
DGP offline, 152
disarmed alarm, 24, 30
door event activation time, 65
door event flag, 40
duress, 152
entry time, 31
exit time, 30
film out, 152
fuse fail, 151
how to trigger, 177
inhibited, 30
keypad buzzer, 153
linking to outputs, 121
local alarm, 30
low battery, 151
mains fail, 151
make event flags 24-hour, 23
pre-alarm, 31
predefined event flags, 178
RAS offline, 152
report failure, 153
shunt event flag, 131
shunt warning, 131
siren fail, 152
system events, 151
system tamper, 151
test mode, 153
triggering macros, 157
warning time, 31
what are event flags, 177
why use event flags, 177
zone, 22
zone event if active, 25
event to output, 121
event flag to link to output, 121
event flags linked by default, 122
invert the output, 122
output number, 121
timezone, 122
troubleshooting, 196
exit fault, 82, 91
external siren event flag, 23
external siren set to, 65
F
facility code. See system code
factory defaults, 113
fault event flag, 35
financial options enabled, 77
forced arming, 55
forced disarm, 55
four-door DGP
set type of DGP, 48
four-lift DGP
set type of DGP, 48
free programmable text on LCD, 149
frequently used detector, 21
G
glossary of terms, 205
GSM line fault, 97
I
ignore battery fault when arming, 80
indicate inhibited zones, 85
inhibit
allow zone inhibit, 19
auto uninhibit on disarm, 73
disable auto uninhibit, 54
inhibit zone tamper, 78
prevent arming if all inhibited, 34
report inhibits, 99
zone shunting, 130
inhibit alarm report on exit fault, 82
inhibit external siren and strobe for disarm
tamper, 82
installer dual code, 84
interconnection fault
override, 90
internal siren, 91
internal siren event flag, 22
internal siren set to, 65
ISDN
MSN number, 94