Installation guide

Advisor Master Programming Guide 221
Ignore battery fault when arming
Override tamper
User can do engineering reset
Override interconnection fault
Engineer entry protect
Override RAS fault
Send arming after exit
Override DGP fault
User offset
Enable buzzer on alerts
End of line resistor code
Internal siren on exit fault
Duress mode
RF jamming set sirens
Siren Type
Number of attempts for PIN of the day
8-Auto reset
Auto reset time
Reset alarm group
9-Communication options
PABX number
Select the reporting format
MSN number
Enter the 1st phone number
Dial tone detection
Enter the 2nd phone number
Select tone dialling
System account number
Enable PSTN line fault monitor
Area account numbers
Monitor service tones
Use BELL modem tones
Use 3 digit SIA extensions
Dual reporting
ISDN point to point
Allow audio listen in
Enable ISDN line fault monitor
Disable reporting of inhibits
200 baud reverse area OP/CL
Reserved
X25 TEI value
X-SIA max characters
Audio listen in time
X25 account code
Audio listen in frame
X25 line type
Report mains fault
Connection type
Report line fault
Suppress FTC for voice
GSM line fault
Retry counter
Select the central station
SIA area modifier
X25 D-Bit
Mains fail reporting delay [min]
Enable IP line fault monitor
AWDGP reporting codes for IMQ
10-Program text
Program text words
11-Version
Select device
12-LED test
13-Timezones
Select timezone
Program start time, hours
Program end time, minutes
Program start time, minutes
Days
Program end time, hours
14-Defaults
Select default option
15-Alarm group restrictions
Restriction number
Alarm group restriction name
1st alternate areas to arm/reset
Timed disarm areas
2nd alternate timed disarm area
Areas to arm/reset
2nd alternate areas to arm/reset
1st alternate timed disarm area
