Installation guide

18 Advisor Master Programming Guide
transmitted depends on the chosen protocol and the selected class and sub-
class. The class holds the basic reporting range (medical, fire, panic). The sub-
class is used to provide differentiation in the event being reported. E.g. The panic
class holds Contact ID codes 120 to 122 or SIA events PA and HA. See Table 14
on page 180.
See “9-Communication options” (page 94), “42-Reporting class database”
(page 161), and “Reporting” on page 180.
Report alarm to CS 1
YES-Report To CS1
*-Change 0-Skip
Use this option to select whether an alarm should be reported to Central
Station 1.
Report alarm to CS 2
See “Report alarm to CS 1”.
Report alarm to CS 3
See “Report alarm to CS 1”.
Report alarm to CS 4
See “Report alarm to CS 1”.
Enable audio listen in
NO-Enable Audio Listen In
*-Change 0-Skip
When Yes is selected, this zone allows for audio listen in on alarm.
Yes: Audio Listen in enabled for this zone.
No: No Audio Listen in.
Engineer Reset on Alarm
NO-Engineer Reset on Alarm
*-Change 0-Skip
Select Yes to enable engineer reset for alarm in this zone. The user can not arm
the area the zone belongs to, until an engineer reset has been performed.
Yes: Engineer reset enabled for alarms in this zone.
No: No engineer reset.
How to perform an engineer reset
Whenever an engineer reset is required, the panel will display a 4-digit code.
This code is a reference to a special code that can be found in the Titan software
package (menu control) or contact your local distributor.