Installation guide

Advisor Master Programming Guide 43
Arm/disarm using one key
NO-Arm/Disarm Using One Key
*-Change 0-Skip
Yes: Provides an option to arm or disarm areas by pressing the number of the
area without Enter, after having entered the user code.
No: Normal alarm control.
Note: This option is only available for areas 1-8.
See Table 5 on page 41 for further information on options available to arming
stations.
Cards auto disarm
NO-Cards Auto Disarm
*-Change 0-Skip
Yes: Allows cards to disarm areas without using the Off key.
No: Only the door is unlocked, except if “Card always arms/disarms” below is set
to Yes or the On/Off key is used.
See Table 5 on page 41 for further information on options available to arming
stations.
Card always arms/disarms
NO-Cards Always Arm/Disarm
*-Change 0-Skip
Yes: Allows cards to arm/disarm areas without using the On/Off keys. Also
“Toggle Area status” on page 41 has to be set to Yes.
No: Normal alarm control.
See Table 5 on page 41 for further information on options available to arming
stations.
Note: The card user's alarm group and the arming station's (reader's) alarm
group must both allow arm and/or disarm functions before a card can be used to
arm/disarm.
Reset from RAS without code
NO-Reset From RAS Without Code
*-Change 0-Skip
Yes: Allows users to reset alarms by pressing Enter, Enter (show alarms)
followed by 0, Enter. The areas in alarm have to be assigned to the arming
stations alarm group.
No: Reset only with user code.
See Table 5 on page 41 for further information on options available to arming
stations.