Installation guide

44 Advisor Master Programming Guide
AG restriction disarm only
NO-AlmGrp Restriction Disarm Only
*-Change 0-Skip
Yes: Users with alarm group restrictions can only disarm or delay automatic
arming. It cannot be used for alarm group restrictions with arm and reset.
No: There is no restriction.
See Table 5 on page 41 for further information on options available to arming
stations.
Entry/exit buzzers
YES-Entry/Exit Buzzers
*-Change 0-Skip
Yes: Enable buzzer for entry/exit timers.
No: No entry/exit timers on buzzer.
Note: Entry time must be >10 seconds.
Timed lockout by wrong codes
NO-Timed Lockout
*-Change 0-Skip
When a wrong code has been entered 10 times, the RAS access is blocked for
90 seconds.
After a correct code with the proper authorisation in the alarm group (Alarm
system control) has been entered, the code tamper event flag will reset.
Yes: On a code tamper, the RAS locks out for time defined in “RAS lockout time”
on page 68.
No: Only event is reported. The RAS is available.
Cards arm after 3 badges
NO-Cards Arm After 3 Badges
*-Change 0-Skip
This is an added option to arm an assigned area. When set to Yes, 3 badges of a
valid card will arm the assigned area(s).
Notes
• The 3 badges must occur within 10 seconds. If not, they will not be
recognised for arming.
• The default is set to No.