Installation guide

Advisor Master Programming Guide 45
Disable status LED's
YES-Disable Status LED's
*-Change 0-Skip
This option disables the optical indicators on the BUS device card readers. The
option to enable or disable the status LED's will have to be set by the user
because not all non-LCD BUS devices are card readers therefore this option will
have to be set based on the hardware connected.
If this option is set to Yes, the panel, when polling / commanding the card reader
RAS, it will not set any of the LED bits in the packet. This will result in the LED's
not being active.
Note: Limitation: Certain card reader settings override the status of command
packet LED bits - i.e. LED's remain illuminated even though LED bits are
disabled. In order to use this feature, it may be necessary to alter card reader
configurations.
Altering card reader configurations:
• For ATS1170 Smart Door Controller:
- Menu 5-Led 1 Options: Led 1: Door Unlocked Only
• For ATS1190 Smart Card Reader:
- Menu 1-Leds On-Line: 1-Blue Led: Door Open Only
- Menu 3-Valid Card Flash: Flash Disabled
- Menu 4-Night Light: Night Light Disabled
3 LED RAS
NO-3 LED RAS
*-Change 0-Skip
If set to Yes, it is possible to configure different actions if the RAS is an
ATS1151/56.
Card & PIN (disarm only)
NO-CARD & PIN (Disarm Only)
*-Change 0-Skip
Yes: Both card and PIN are required to disarm the system.
No: The system will disarm with card or PIN.
Notes
• The default is set to No.
• See also “RAS card & PIN timeout” on page 67.
• The option can only be used with devices that support both card badge and
PIN entering.