Installation guide

46 Advisor Master Programming Guide
RAS tamper (ACPO) area
RAS Tamper (ACPO) Area 1
Area:
Allocates the RAS to an area for alarm and tamper.
The default is set to Area 1.
Card & PIN (always)
NO-Card & PIN (Always)
*-Change 0-Skip
Yes: Both card and PIN are required to:
• Arm, disarm and reset the system
• Open a door
• Have access to any installer or user menu
No: The system (with card only) can:
• Arm, disarm and reset the system
• Open a door
The system (with PIN only) can:
• Arm, disarm and reset the system
• Open a door
• Have access to any installer or user menu
Notes
• If this option is set to Yes, then the option “Cards arm after 3 badges”
described on page 44 is not functional.
• The option can only be used with devices that support both card badge and
PIN entering.
Enter unlocks screen saver
NO-ENTER Unlocks Screen saver
*-Change 0-Skip
If the screen saver is active, PIN / Enter unlocks the screen saver, without
performing any further action. After the screen saver is unlocked, keypad
operation is normal, until the screen saver again becomes active.
RAS code tamper event flag
RAS Code Tamper No Event Flag
Event Flag:
When a wrong code has been entered 10 times the RAS access will be blocked
for 90 seconds. At the same moment the event flag “Code tamper” will be
triggered.
See also “Timed lockout by wrong codes” on page 44.