Installation guide

Advisor Master Programming Guide 53
List of areas
NO-Prompt With List of Areas
*-Change 0-Skip:
Select whether the areas assigned to a user are displayed during the arm/disarm
procedures.
Yes: After the user has entered a PIN and pressed On or Off, the areas assigned
to the user are displayed. The user can then select from the arm/disarm options
(e.g., specific areas, all areas, etc.).
This feature is useful when a user can control several areas but usually only
arms/disarms specific areas.
No: The areas assigned to the user are not displayed. Areas are immediately
armed/disarmed once the user has entered a PIN and pressed On or Off.
Press 0 to go to the user menu items available.
Keypad duress
NO-Can User Activate Keypad Duress
*-Change 0-Skip:
Enables the use of the duress facility using a code.
Yes: A code can be entered on a keypad to activate duress.
No: Duress cannot be activated. A duress code is treated as an invalid code.
Refer to the Manager Manual for further information on duress.
Press 0 to go to the user menu items available.
Reset system alarm
NO-Reset System Alarms
*-Change 0-Skip:
This record allows the alarm group to reset latching system alarms. System
alarms are conditions, such as DGP tamper, siren fail, low battery, report fail, etc.
Yes: A user with this alarm group can reset the latching system alarms.
No: A user cannot reset latching system alarms.
Press 0 to go to the user menu items available.
Note: If this record is set at Yes, “Alarm system control” on page 52 must also be
set to Yes and “Latching system alarms” on page 74 has to be set to Yes (see “7-
System options”).