Installation guide

66 Advisor Master Programming Guide
Siren delay set to
Siren Delay Set to (Min)
Time:
This option allows you to set the delay time (0 to 255 minutes) before the sirens
actually activate after an alarm has occurred. This can be used for recording any
sounds before the siren activates.
The siren delay is set to 0.
Mains fail delay time
Mains Fail Delay Time (Min). 10
Time:
The delay time (0 to 255 minutes) before a Mains Fail is reported to the central
station. Enter a value of “0” for no delay.
See also “34-Program system event flags” on page 151 and “9-Communication
options” on page 94.
Delay reporting alarms for
Delay Reporting Alarms for (Sec). 0
Time:
The delay time (0 to 255 seconds) before a burglar alarm (BA) or BA Class
Tamper Alarm (TA) is reported to the central station. Can be used to prevent
alarm reporting for users that have problems disarming their area in time. After a
burglar alarm or input tamper activation the burglar alarm (BA) or BA Class
Tamper Alarm (TA) will be reported to the Central Station after the delay time has
expired. All other (non-BA & non-TA) Alarms are reported immediately, without
delay.
A to B alarm delay (ACPO)
A to B Alarm Delay (ACPO) for (Min). 0
Time:
The delay time (0 to 255 minutes) that the system waits for a second alarm. If the
second alarm happens within the delay time, it will be reported as a verified
alarm.
Note: See also “A&B alarm reporting (ACPO)” on page 34 in “2-Area database”.
Screen saver timeout time
Screensaver Timeout (Sec). 0
Time:
The screen saver timeout value will be in the range of 5 to 180 seconds with an
accuracy of 1 second. The screen saver timer will be reset with the programmed
period every time a RAS key is pressed when the screen saver is not active. The