Installation guide

74 Advisor Master Programming Guide
Yes: One zone at a time is displayed even though there may be more than one in
the list of zones to be displayed. The user must scroll through the zones. eg.
Active 2. Building 1 Workshop PIR.
No: Zones are displayed as a list of numbers and it is necessary to select the
zone number to display the individual zone name. eg. Active 1, 2, 3.
Press 0 to skip further options and leave system options.
Username file
YES-Username File
*-Change 0-Skip
Determines if users have names with their PINs programmed. Only users 1 to
200 can have a name with their PIN (if memory extension available).
Yes: The appropriate prompts for programming a username, are displayed when
programming user codes.
No: The appropriate prompts for programming a username, are not displayed
when programming user codes.
Press 0 to skip further options and leave system options.
See also Advisor Master Manager Manual regarding programming users.
System alarms set siren and strobe
NO-System Alarms Set Siren & Strobe
*-Change 0-Skip
Indicate whether system alarms should activate siren and strobe.
Yes: The dedicated tamper zones on the ATS control panel and the DGP’s
activate the siren and strobe when in alarm.
No: The system alarms report and activate event flags (if programmed) only.
Press 0 to skip further options and leave system options.
Latching system alarms
NO-Latching System Alarms
*-Change 0-Skip
System alarms are RAS/DGP Offline, cabinet tamper, siren tamper, mains fail,
fuse fail, low battery, etc.
Yes: System alarms latch and require a code to reset. If set to Yes, ensure that
users who have the appropriate authority are assigned an alarm group that has
"Reset System Alarms" set to Yes.
No: System alarms automatically reset and report restoral when the alarm
condition is no longer present.
Press 0 to skip further options and leave system options.