Installation guide

76 Advisor Master Programming Guide
Disable code from displaying
NO-Disable PIN Code From Displaying
*-Change 0-Skip
Disable display of the PIN when programming users
Yes: PINs are not visible (except for master installer). The display shows “PINs
can not be viewed”.
No: PINs are visible to.
Press 0 to skip further options and leave system options.
See also Advisor Master Manager Manual regarding programming codes.
Disable flashing area LEDs
NO-Disable Flashing Area LEDs
*-Change 0-Skip
Indicate if area LED’s should flash when there is an alarm and/or tamper alarm in
the area.
Yes: The area LED will not flash on alarm.
No: The area LED will flash on alarm.
Press 0 to skip further options and leave system options.
Two users before programming code
NO-Two Users before Programming Code
*-Change 0-Skip
Determines that two users are required to enter their PIN to enable programming
of users (user menu 14). When entering this option, a request for a second PIN is
shown before access is granted.
User 50 (Master code) is not required to have a second code to authorise the
option.
Yes: Two users are required to enter their PIN before access is granted to
program users.
No: No validation is needed when entering user menu 14, Program users.
Press 0 to skip further options and leave system options.
See Advisor Master Manager Manual for more information on programming
users.
Display alarms instantly on LCD
NO-Display Alarm Instant On LCD
*-Change 0-Skip
Indicate if alarms should be displayed immediately on LCD.