Installation guide

82 Advisor Master Programming Guide

both are active, thus generating a DC voltage at the siren output. The following

happens when the following output are activated:

• 12th output active = generates constant DC voltage at the siren output

• 13th output active = generates a warble tone at the siren output

• 14th output active = generates a sawtooth tone at the siren output

• 15th output active = generates 2 tones at the siren output

• 16th output active = generates an inverted sawtooth tone at the siren output

Inhibit alarm report on exit fault

YES-Inh. Alm. Rpt. On Exit Fault

*-Change 0-Skip

This option inhibits reporting of alarms with a reporting code of 17-24(burglar

alarm) when the exit timer is running. If set to Yes during the exit time, alarms on

inputs with reporting codes of 24 (burglar alarm) will set a flag to disable further

reporting. This is known as an ‘exit fault’. When the area is in Disarm, this flag is

reset. These inputs will log as ‘exit fault’ & ‘exit fault restore’ while the flag is set

or during the exit time. Burglar alarms in exit time will only activate the internal

siren.

Disable tamper report in disarm

YES-Disable Tamper Report in Disarm

*-Change 0-Skip

If set to Yes, a zone input tamper/restore will not report to the central station if

the assigned area(s) are disarmed. Similarly, system tampers/restores will not

report to the central station if all areas are disarmed. If a tamper occurs when the

area(s) are armed, this will report and send the restores when the areas are

disarmed.

Inhibit ext.sir&strobe for disarm tamper

YES-Inh. Ext. Siren & Strobe in Disarm

Tampers

*-Change 0-Skip

If set to Yes, zone input tampers will only activate the internal siren if the areas

are disarmed. System tampers operate similarly except that all areas are

disarmed.

ATS system code

ATS System Code

Code:

If the system code is 00000, the old algorithm is used to calculate the

engineering reset code. If not, the system code value and the engineering code

value are used in a special calculation to generate the reset code.

The default is set to 00000.