Installation guide

Advisor Master Programming Guide 3
If the programming of the system is done, the system has to be tested. Menus
providing support in testing are:
Table 1: User menus
1-Panel status
Provides system information.
2-Active zones
Shows zones not in normal state (e.g. active or tampered).
3-Zones in alarm
Shows any zone in alarm.
4-Inhibited zones
Shows any inhibited zone.
5-History
Lists all events that occured.
6-Test report
Use this menu to perform an arm or disarm test.
10-Inhibit zone
Inhibit any zone.
11-Uninhibit zone
Uninhibit any zone previously inhibited.
12-Walk test
Test any individual zone.
13-Start Auto Disarm test
Use this menu to perform an auto disarm test.
16-Isolate/De-isolate RAS/DGP
Isolate or de-isolate any RAS or DGP.
22-Open door
Open a door for the programmed unlock time.
23-Unlock, Lock, Disable or
Enable Doors
Using this menu doors can be unlocked until locked again
with this menu. Disable or enable doors.
Table 2: Installer menus
11-Version
Verify version numbers for the control panel, any RAS or
DGP.
12-LED test
Activate all LED’s on all RAS’s.
14-Defaults
If required, all settings or only a part can be reset to factory
defaults.
23-Poll errors
Use this option to view if communication errors occured on
the system databus.
25-Display last card
Display the system code and CARD ID when using the 1-door
RAS’s like the ATS1170, or RASes like ATS1190 / ATS1192.
31-Battery testing
Test DGP batteries.
56-Siren calibration
Verify the siren connection, and align the activation
parameters.