Installation guide

86 Advisor Master Programming Guide
Eng Rst on ACPO system B tamper
YES-Eng Rst on system B tamper
*-Change 0-Skip
Enables engineer reset lockout for ACPO system B-tamper/offline.
Security grade
The Security grade option allows the panel behaviour to change based on the
grade level of the installation. The following grade levels are implemented:
• Disabled: Existing ATS panel behaviour
• Grade 2: Low to medium risk installation
• Grade 3: Medium to high risk installation
There are conditions in the current panel implementation that already prevent
arming, and cannot be overridden (e.g. unsealed zone, zone/system alarm,
zone/system tamper, engineering reset). These conditions must be either
restored, or the zone/device inhibited, before arming can proceed.
In addition to the current conditions that prevent arming, there are additional
conditions that must prevent arming when the selected security grade is option 3.
When the security grade is not Disabled, these new conditions can prevent a
security system from arming, however, may be overridden by authorised users.
When an event is overridden, the event is logged to the alarm history database
including time and date, and the number of the user who performed the override.
To discriminate between the levels, use option “User level” (described on page
60) in the Alarm Group menu.
Note: Security grade 3 also sets minimum PIN length to 6 digits.
Ignore AC mains fault when arming
NO-Ignore AC Mains Fault when arming
*-Change 0-Skip
Enables to arm the system without mains power supply.
Latch mains/battery/line faults
NO-Latch Mains/Battery/Line Faults
*-Change 0-Skip
When set to Yes, all conditions latch. Once latched, a user PIN is required to
reset the event. When this option is set to No, each event automatically clears
once the condition has been restored