Operating instructions

FOREWORD
Your decision to purchase an Eclipse Wirefree Solar
Alarm System represents a major and sensible step
towards total protection of your premises, its contents
and its occupants.
The Eclipse Wirefree Solar Alarm System complies with
the requirements of BS6799 Class 1 for Wireless Alarms.
All components are designed and manufactured to
provide a high standard of security protection and long,
reliable service. In addition, the radio devices are tested
and approved by the Radio Regulatory division of the
Department of Trade and Industry (DTI) to ensure that
they will not interfere with other radio equipment. No
radio licence is required, however, the approved radio
frequency is not protected from interference and may be
withdrawn from use at any time subject to the DTI giving
users an appropriate notice period.
The Eclipse Wirefree Solar Alarm System is purposely
designed for installation by non-experienced people
using only conventional domestic tools. However, it is
essential that the lnstaller reads and fully understands
the advice and procedures contained in this manual
before proceeding with the installation. This manual
should be retained for future reference.
During installation, it is also important that the
procedures are followed in sequence.
IMPORTANT NOTE
All components, with the exception of the External
Solar Siren are only suitable for internal use.
SYSTEM SECURITY
This system has been designed to both detect intruders
and act as a strong deterrent to would-be intruders.
Please remember that given adequate knowledge and
time it is possible to overcome any alarm system and
we therefore recommend that an Intruder Alarm is used
in conjunction with good physical protection such as
security window and door locks.
The system is operated from one or more Remote
Control Units, which are encoded by the user to his/her
own House Code. The House Code can be changed at
any time by the user to suit the circumstances.
Care should be taken to ensure that your Remote
Control Unit(s) are not lost as the finder could Disarm
your alarm before you are able to re-code the system.
CONTENTS
Page No.
INTRODUCTION 1
PLANNING AND EXTENDING YOUR
WIREFREE SOLAR ALARM SYSTEM 2
WIREFREE EXTERNAL SOLAR SIREN
General Information 3
Location 3
Installation 3
Settings 4
Initial Power-up 4
Jamming Detection 4
REMOTE CONTROL UNIT
General Information 5
Setting up the Remote Control 5
WIREFREE PASSIVE INFRA RED MOVEMENT
DETECTORS (PIR’s)
Installation 6
Setting 7
Testing 7
OPTIONAL : WIREFREE MAGNETIC
CONTACT DETECTORS
Installation 7
TESTING THE SYSTEM 8
OPERATING INSTRUCTIONS 9
MAINTENANCE 10
ENTRY/EXIT DELAY OPTION 10
TROUBLE SHOOTING 11
EXTENDING YOUR SYSTEM 12
SPECIFICATION Back Cover
E100 Wirefree Alarm SystemResponse