Operating instructions

6. Slide the batteries supplied into the battery holder,
ensuring that the positive (+) side is uppermost on
each battery as it is installed.
7. Carefully refit the battery holder into the detector
ensuring that the spring connectors slide onto
either side of the circuit board.
Note: As soon as the battery holder is connected, the
Control Unit will emit a two tone alarm for 3 seconds
and the Tamper/PA Zone LED will illuminate. This
confirms that the House Code is correct and that the
detector is within radio range of the Control Unit.
8. Refit the battery cover by placing it over the
batteries and sliding it on.
9. Test the operation by opening the door/window.
The LED on the detector will light for approx.
1 second and then extinguish each time the magnet
is parted from the detector.
The Control Unit will also emit a 3 second alarm
tone each time the detector is operated and the
appropriate Zone LED will be illuminated to
confirm the Zone selected.
Once you have completed installing all your
detectors, take the Control Unit out of Test mode
by pressing the button. The Control Unit will
emit 2 bleeps and the Power LED will illuminate
steadily.
INSTALLING AND
SETTING THE EXTERNAL
SOLAR SIREN & STROBE
The Solar Siren & Strobe Unit should be fitted to the
outside of the building in a position that is clearly
visible and at a height which is relatively inaccessible
to an intruder.
The Solar Siren & Strobe incorporates a solar panel
which will maintain a charge to the integral 6 Volt
1.2Ahr sealed lead acid rechargeable battery during
daylight hours. During the night, a negligible amount
of energy is released by the rechargeable battery
to operate the Siren & Strobe. The Solar Siren &
Strobe is self maintainable during darkness and
long winter periods.
LOCATION
To provide the optimum amount of daylight to the
Solar Panel, you should ideally mount the Solar Siren
& Strobe on a south facing wall. However, an easterly
or westerly position will suffice.
Although the Solar Siren & Strobe is designed to work on
any aspect wall, for optimum performance you should
refrain from siting the Unit on a north facing wall where
possible. Shadows cast by neighbouring walls, trees and
ZONE SETTING
Switches 9 + 10
SW9
ON
ON
OFF
OFF
SW10
ON
OFF
ON
OFF
Zone
1
2
3
4
Tilt and
remove
battery
holder and
insert two
batteries
Double Sided Tape
OR Screw Fixing
Raised Head Screw,
Key-hole Slot Fixing
Small Counter-sunk
Screw Fixing
Battery
Connector
Slide Open and Lift Off
Do Not Use A Screw Driver
Detector
Magnet
Alternative
Mounting
House Code
Location of key-hole
screw (underside)
Hole for mounting
screw
Printed
circuit board
Anti-tamper
switch
ON
1 2 3 4 5 6 7 8 9 10
8mm
11mm
12 Eclipse E400