Operating instructions

ManualsBrandsResponse Alarms ManualsCarbon Monoxide AlarmE400 Wirefree

With the Control Unit in Test/Programming mode

Enter

A Zone LED will illuminate to indicate the setting:-

(factory default 3 minutes - Zone 3 LED ‘ON’). To

change the setting press the appropriate key to

illuminate the associated Zone LED:- (Note: 10 minutes

setting will be indicated on the Tamper/Personal

Attack/Zone 5 LED).

Press to memorise the setting and to revert to the

Test/Programming mode.

5. PART ARM/ZONE OMIT

Any of the Zones 1-5 can be omitted (ie. made in-active)

when the system is Part Armed. This will enable you to

Arm only the selected (active) Zones when you Part Arm

the system.

With the Control Unit in Test/Programming mode

Enter

The Zone LEDs 1- 4 and Tamper/Personal Attack/Zone

5 LED will illuminate to indicate the Zones which are

OMITTED (in-active) when the system is Part Armed:-

Factory default:-

Zones 3 and 4 omitted - Zones 3 and 4 LEDs ‘ON’

(ie. Zones 1, 2 and 5 are Active in Part Arm)

To add or delete an omitted Zone, press the number of

the Zone to illuminate or extinguish the appropriate

Zone LED.

Press to memorise the setting and to revert to the

Test/Programming mode.

6. EXIT/ENTRY DELAY TONES

During the Exit/Entry delay periods the Control Unit may

be set to either emit a constant Exit/Intermittent Entry

bleep tone or two short bleeps at the beginning and end

of the delay time (semi silent), depending on the

programming.

With the Control Unit in Test/Programming mode

Enter

Zone 1 LED will indicate the setting:-

LED ‘ON’ - constant Exit/Intermittent Entry bleep

tone selected

LED ‘OFF’ - semi silent Exit/Entry bleeps selected

Factory default:-

Constant Exit/Intermittent Entry bleep tone ‘ON’ - Zone 1

LED ‘ON’

Press as required to select the delay tone required

Press to memorise the setting and revert to the

Test/Programming mode.

7. JAMMING DETECTION SYSTEM

In order to detect any attempts to illegally Jam the radio

channel used with your alarm system a sophisticated

Jamming Detection system is incorporated into the

Control Unit. If this feature is selected and the radio

channel is continuously jammed for more than 30

seconds, when the system is Armed or Part Armed, the

Control Unit sounder will emit a pre-alarm series of

rapid bleeps for 5 seconds. If the Jamming continues

for a further 10 seconds or more, a Full Alarm will occur

indicated by the Internal and External Alarms sounding

and the Tamper/Personal Attack Zone LED illuminating.

The Jamming Detection circuit is designed to scan for

jamming signals. However, it is possible that it may

detect other local radio interference operating legally or

illegally on the same frequency. If it is planned to

operate the jamming detection feature we recommend

that the system is monitored for false jamming alarms

for at least 2 weeks prior to leaving the Jamming Detect

function on permanently.

With the Control Unit in Test/Programming mode

Enter

Zone 1 LED will indicate the setting:-

LED ‘OFF’ - Jamming Detection system ‘OFF’

LED ‘ON’ - Jamming Detection system ‘ON’

Factory default:-

Jamming Detection ‘OFF’, Zone 1 LED ‘OFF’

Press as required to select the Jamming Detection

‘ON’/‘OFF’

Press to memorise the setting and revert to the

Test/Programming mode.

minute

Press

Alarm

Time

minutes

2345

16 Eclipse E400