Operating instructions

8. USER ACCESS CODE
The Control Unit is supplied with a preset User Access
Code of . This code allows general
operation ( Arming/Disarming etc) and programming/re-
programming of the system at the Control Unit.
However, for security reasons, it is essential that you
change the User Access Code to another four-digit
number which only you and other users of the system
will know and use (usually a number with a personal
significance is easier to remember).
To change the User Access Code:-
With the Control Unit in Test/Programming mode
Enter
Zones 1 - 4 LEDs will be illuminated.
Enter your new Access Code
The Zone LEDs 1-4 will extinguish as each digit is
entered.
Press to memorise the setting and to revert to
Test/Programming mode.
IMPORTANT: The Control Unit will only recognise the
entering of the new User Access Code from now on. If
you should forget your Access Code and need to
change it, you will need to completely power down the
Control Unit and reset the memory link to ‘OFF’ to revert
the Access Code and all the other programmable
functions back to the factory default settings.
9. SIREN CODE
A small radio transmitter is incorporated within the
E400 Control Unit to operate and control the External
Solar Siren & Strobe. To enable the Control Unit to
communicate with the External Solar Siren & Strobe
the Siren Code set in the External Siren (see page 13)
needs to be programmed into the Control Unit.
This is done by temporarily resetting the House Code in
the Remote Control to the Siren Code and teaching the
Siren Code to the Control Unit.
To programme the Siren Code into the Control Unit,
with the Control Unit in Test/Programming mode
Enter
The Control Unit’s row of 8 LEDs will indicate the Siren
Code switch setting selected for each two position
switch as follows:-
Switch set ‘ON’ - LED ‘ON’
Switch set ‘OFF’ - LED ‘OFF’
Factory default:- switches 1, 3, 5, 7 ‘ON’
To enter/change the Siren Code, refer to the Siren Code
switch 1-8 settings previously set in your Solar Siren &
Strobe, remove your Remote Control’s battery cover
and temporarily reset the miniature switches 1-8 in the
Remote Control to the Siren Code. Press and release
the ‘OFF’ button on the Remote Control. The Control
Unit will acknowledge the signal by bleeping twice and
the Control Unit LEDs 1-8 will illuminate to indicate the
new Siren Code setting.
Press to memorise the Siren Code setting and to
revert to the Test/Programming mode.
RESET YOUR REMOTE CONTROL MINIATURE
SWITCHES TO YOUR HOUSE CODE AND REPLACE
THE BATTERY COVER.
Programming of your Control Unit is now complete.
Exit Test/Programming mode by pressing again.
EXTERNAL CONNECTIONS
The Control Unit incorporates a terminal block for
external connection of a Hard-wired Siren, Telephone
Dialler or a Hard-wired Zone 5 trigger input.
To access the terminal block, set the Control Unit to
Test/Programming mode by
Entering
and open the Control Unit cover. (The alarm will sound
on ‘Test’).
Before making any connections, ensure that the
memory link is in the ’ON’ position and then remove the
power (mains and Back-up Battery).
Full details of the Control Unit terminal block
connections are shown overleaf.
After making your external connections reconnect the
power supply and Back-up Battery and close the
Control Unit front cover.
????
8
0
1234
????
Access Code
17Eclipse E400