Operating instructions

INTRODUCTION AND
OVERVIEW
The E400 Wirefree Alarm System is designed to
allow flexibility in configuring and using the system.
The detectors can be set to operate on any one of
4 Zones, to give an instant alarm or a timed entry
delay. There is no limit to the number of detectors that
can be installed per Zone.
A normally closed, Hard-wired Zone input is also
available on Zone 5.
Part Arm allows only selected detection Zones to be
Armed. For example, for night time protection you can
‘Arm’ the downstairs areas, garage and outbuildings,
whilst allowing you free access to the upstairs areas
without activating your alarm.
The Control Unit is programmed and operated via its
integral keypad. A User Access Code allows general
operation and full access to the programming menu.
Wired output facilities are available for connection to a
Telephone Dialler or Communicator or Hard wired
External Siren & Strobe.
The Control Unit also incorporates a sophisticated
Jamming Detection Circuit with pre-alarm indication.
The E400 Intruder Alarm package contains all the
components necessary to install a complete Intruder
Alarm System within your premises. You can increase
your protection by adding additional Wirefree Passive
Infra Red Movement Detectors and Wirefree
Magnetic Contact Detectors either at the time of
initial installation or at a future date. You may also
wish to purchase additional Remote Control Unit(s)
for use by other members of your household. Full
details of other accessories to extend your system
are given on page 24.
The items included in your E400 package are shown
opposite.
EXTENDING THE ECLIPSE
E400 SYSTEM
The following additional accessories are available to
enhance your system and provide further protection
and a higher level of security where required.
Part No Description
CA2000P Wirefree Passive Infra Red Detector
CA2000M Wirefree Magnetic Contact Detector
CA2000R Remote Control Unit
E100D Dummy External Siren
2 Eclipse E400