Operating instructions

LOCATION
When choosing a suitable location for the Control Unit,
the following points should be considered.
1. Ensure that the Control Unit is within a protected
area with the system Armed, ie. an intruder cannot
reach the Control Unit without opening a protected
door or being detected by a movement detector.
2. The position selected must be within reach of a
13A socket.
3. The Control Unit should be close to the Entry/Exit
door but not visible from the door or windows.
4. Do not locate the Control Unit closer than 1 metre
to any large metallic object eg. mirrors, radiators,
fridge-freezers etc., as this may affect the radio
range.
5. Locate the Control Unit in any easily accessible
position, between 1.5 and 2 metres above floor level
and in a position where it will be seen each day.
CONTROL UNIT
INDICATORS AND KEYPAD
View of Control Unit Indicators and Keypad
Detector Low
Battery LED
ZONE
1234ON
12
3
45
6
789
0
Personal Attack Button
Programme Button
Part Arm Button
Full Arm Button
Disarm Button
Power LED:
ON:- Adaptor Power (Normal)
OFF:- Battery Power Only
FLASHING:- Test/Programming Mod
e
Tamper/Personal Attack/Zone 5
Alarm LED:
ON:- Tamper/PA Zone
Alarm Activation
FLASHING:- Hard-wired Zone 5
Alarm Activation
System Status LED:
ON:- System Fully Armed
OFF:-
System Part ArmedFLASHING:-
System Disarmed
Wirefree Zones 1-4
Alarm Activated
LED's
Keypad
Digits 0-9
5Eclipse E400