Operating instructions

INSTALLATION
1. Undo the two front cover retaining screws and hinge
the Control Unit cover down. Remove the Control
Unit Back-up Battery.
2. Hold the Control Unit in position and mark the
four fixing holes. A small spirit level placed on top
of the Control Unit will ensure that the panel is
level. Note that the bottom fixings are keyhole
type so the holes should be marked at the top of
the keyhole.
3. Remove the Control Unit and drill four, 4mm
diameter fixing holes.
IMPORTANT NOTE: Do not drill the fixing holes
with the Control Unit in position, as the resulting
dust could seriously affect the system electronics
and invalidate the guarantee.
4. Fully insert the plastic wall plugs supplied and screw
the Control Unit to the wall using the four screws
supplied. Be careful when fitting the bottom right
hand screw not to damage the ribbon cable.
5. Ensure that the Control Unit Siren Plug is plugged
into the socket on the circuit board.
PROGRAMME MEMORY
The Control Unit incorporates a ‘Non Volatile Memory’,
which will memorise all programme settings indefinitely
even when all power has been removed. To enable this
facility to operate, the memory link must be set to the
‘ON’ position.
If, for any reason, you wish to erase the programme
memory and reset the Control Unit to the factory
settings, remove all power (mains and Back-up Battery),
set the memory link to ‘OFF’ and then re-apply power.
In all other circumstances the memory link should be
left in the ‘ON’ position.
Back-up Battery
Compartment
Hard-wired Siren Tampe
r
Return Link
Control Unit
Anti-Tamper Switch
PCB Protection
Cover
Control Unit
Siren Plug
Ribbon Cable
Screw Cover
Plu
g
s
Power Jack Socket
Terminal Block
(See page 18 for details)
Memory Link
ON
Control Unit Siren
View of Inside
of Control Unit
6 Eclipse E400