Operating instructions

ManualsBrandsResponse Alarms ManualsHome building and DecorSA1

CA2000KP - Wirefree Security Keypad

These instructions should be read in conjunction with your

system Installation and Operating Manual and retained for

future reference.

Introduction

The CA2000KP enables any authorised user to Arm and Disarm the

Alarm System by simply entering a four digit 'Access Code' at the

Keypad, and is only suitable for use with the following Response

alarm systems: CA610, E100, E200, S100 variants, SA1, SA2, S200

and WA510.

The Keypad is designed for wall mounting inside the property

within a protected area (usually in the Hall adjacent to the main

entrance door) and therefore always arms your system with a 15

second Entry/Exit Delay, to enable you to leave the property after

arming, and to enter the property and disarm at the keypad during

the Entry Delay period. The keypad also incorporates a ‘PANIC’

facility to initiate a full alarm in the event of threat or danger.

Installation

IMPORTANT: DO NOT fix the Keypad to metalwork or locate the

unit within 1m of metalwork (ie. radiators, water pipes etc.) as this

could

affect the radio range of the keypad. This Keypad is not

weatherproof

and must be installed indoors.

1. Before commencing installation of the keypad you should

set your system to Test/Service mode (refer to your system

Installation and Operating Manual for details).

2. Undo and remove the back-plate securing screw from the

bottom of the unit and remove the back-plate.

3. Using the back-plate as a template, mark the positions of the

two fixing holes on the wall, remove the back-plate and drill two

4mm holes and insert the plastic wall plugs supplied. Secure

the back-plate directly to the wall using the screws supplied.

4. Using a ball point pen set the miniature dip switches 1-8 to the

same combination of ‘ON’ and ‘OFF’ as the House Code dip

switches in the other items in your system.

5. Connect the 9 Volt battery to the connector and place the

battery into the battery compartment.

6. Fit the Keypad to the back-plate and secure using the fixing screw.

Installation and Operating Instructions

View Inside Keypad

(Viewed upside down)

Push Button

keypad

OFF

Back-plate

Securin

Screw

On-Ai

Light

House Code Dip Switches 1-8

9 Volt PP3 Alkaline Batter

1 2 3 4 5 6 7 8

nti Tamper

Switch

Summary of content (2 pages)

PAGE 1
CA2000KP - Wirefree Security Keypad Installation and Operating Instructions These instructions should be read in conjunction with your system Installation and Operating Manual and retained for future reference. Introduction The CA2000KP enables any authorised user to Arm and Disarm the Alarm System by simply entering a four digit 'Access Code' at the Keypad, and is only suitable for use with the following Response alarm systems: CA610, E100, E200, S100 variants, SA1, SA2, S200 and WA510.
PAGE 2
Installation and Operating Instructions - continued Setting Your Access Code The Keypad is supplied with a preset Access Code of: 2 1 3 4 However, for security reasons, it is essential that you immediately change the Access Code to another four digit number which only you and other users of the system know (usually a number with a personal significance is easier to remember).