Night Stand Contains One (1) Night Stand and Hardware IMPORTANT NOTE: TOOLS REQUIRED: Carefully remove all the parts from the box, Arrange on a flat -Phillips Screwdriver surface and verify you have all of the following parts and hardware Hammer 1.Top Panel (1 PC) 2.Bottom Panel (1 PC) 3.Left Panel (1 PCS) 4.Right Panel (1 PCS)
ASSEMBLY INSTRUCTIONS STEP 1 Tap Dowels (B) into the Top Panel (Part 1), Bottom Panel (Part 2), Top Support Bar (Part 5) and Plinth Panel (part 6) in the larger holes provided. Tap Wood Dowels (C) into the 2 Front Door Panels (Part 8) in the larger holes provided. Screw in the Mini fix Bolt (D) into the Left Panel (Part 3) STEP 2 and the Right Panel (Part 4) in the smaller holes provided.
ASSEMBLY INSTRUCTIONS STEP 3 Insert Mini fix House (Part E) into Top Support Bar (Part 5), Plinth Panel (Part 6), Top Panel (Part 1) and Bottom Panel (Part 2) as shown. “Without edging/veneer facing downward Attach Top Support Bar (Part 5) to Left Panel (part 3) as shown. Turn the Mini fix House to tighten using the Allen Key. Cover the Mini fix House using the Mini fix Cap (F) by pressing it into the Mini fix House. This is how a mini fix works...
ASSEMBLY INSTRUCTIONS STEP 5 Attach Top Panel (Part 1) to the Left Panel (Part 3) as shown. Tighten by turning the Mini fix house (E) using the Allen Key. Cover the Mini fix House using the Mini fix Cap (F) by pressing it into the Mini fix House. This is how a mini fix works... The head of the mini fix +72 housing cogs into the open mouth of the mini fix bolt. i You then turn the mini fix a ‘housing so it tightens over the mini fix bolt. *Without edging/veneer facing downward *Attach Mini fix Cap as shown.
ASSEMBLY INSTRUCTIONS Attach the Plinth Panel (Part 6) to the left STEP 7 panel (Part 3) as shown. Tighten by turning the Mini fix house (E) using the Allen Key. Cover the Mini fix House using the Mini fix Cap (P) by pressing it into the Mini fix House This is how a mini fix works... The head of the mini fix &a0#% housing cogs into the open : ‘month of the mini fix bolt. 2 You then tum the min fix Re. housing so it tightens “aver the mini fix bolt *Attach Mini fix Cap as shown.
ASSEMBLY INSTRUCTIONS Screw the Door Spring Base (I) into the top panel using 16 mm Screws (H) and a Phillips Head Screw Driver. Attached the Door Spring to the Base as shown. STEP 10 Tap the White Nails (L) to the bottom of the side boards as shown.
ASSEMBLY INSTRUCTIONS STEP 11 Attach the Back Panel (Part 9) to the back of the Nightstand using 16 Nails (M) and a hammer. Attach the Door Front Panels (Part 8) to the Door Panel (Part 7) using eight 30mm Screws (G) and a Phillips Head Screwdriver. Attach the screws in the holes indicated.
ASSEMBLY INSTRUCTIONS Insert the two Door Supports (K) in the holes indicated on the top and bottom of the Door Panel. STEP 13 Attach the Magnet Spring (J) to the Door Panel where indicated using a Phillips Head Screwdriver. STEP 14 Attach the Door panel to the Nightstand by pressing down on the 2 Door Supports and lining them up with the holes in the top panel.
