Instructions / Assembly

STEP 8 STEP 9

Install the Support Brackets (Part D) to attach

the rails using 3/8” Bolts (Part I).

Secure the bolts tightly.

Note: There are a total of 4 bolts for the two

support brackets.

Adjust the wing nuts to make the rails straight

and tight.

SETUP INSTRUCTIONS

ASSEMBLY INSTRUCTIONS (CONTINUED)

STEP 6 STEP 7

First install the Short Rail (Part A) to the platform

frame using 1/2” Bolts (Part K). If the holes do not

line up - adjust the adjustment wing nuts until

the holes line up with the brackets. Install Long

Rails (Part B) using 1/2” Bolts (Part K). Secure the

bolts tightly.

Use 5/8” Bolts (Part J) to attach the end legs.

Secure the bolts tightly.

SIZES: DB, QN, EK, CK

PAGE 1
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 6 STEP 7 J K SETUP INSTRUCTIONS SIZES: DB, QN, EK, CK B B A Use 5/8” Bolts (Part J) to attach the end legs. Secure the bolts tightly. STEP 8 First install the Short Rail (Part A) to the platform frame using 1/2” Bolts (Part K). If the holes do not line up - adjust the adjustment wing nuts until the holes line up with the brackets. Install Long Rails (Part B) using 1/2” Bolts (Part K). Secure the bolts tightly.
PAGE 2
Platform Bed Setup Instructions ASSEMBLY INSTRUCTIONS Contains One (1) Bed and Hardware SIZES: DB, QN, EK, CK IMPORTANT NOTE: STEP 1 TOOLS REQUIRED: Carefully remove all parts from the carton. Arrange on a flat surface to verify all of the following parts and hardware are present. Phillips Screwdriver PART LIST A. Short Rail B. Long Rail (1 pc) C. L-Brackets (2 pcs) (2 pcs) D. Support Brackets (2 pcs) Unfold each half and lay flat upside down. Raise all six legs to upright position.