User's Manual

RXiBreeze PAP System User Manual
12
To connect your breathing circuit to the device, please follow the below steps:
1. Install the connector to the back of the device, and connect the tubing with it.
Note: If you are using a standard tube (not shown) instead of a heated tube, simply
slide the tubing over the air outlet port on the therapy device.
2. Connect the tubing to the mask. For specific parameters and the correct use of the
method, please refer to the breathing hose manual.
WARNING: Do not pull or stretch the tubing, this could result in circuit leaks.
Inspect the tubing for damage or wear. Discard and replace the tubing as necessary.
3. Attach the headgear to the mask if necessary. For specific parameters and the
correct use of the method, please refer to the mask manual.
WARNING:
 If you are using a full face mask (a mask covering both your mouth and your nose),
the mask must be equipped with a safety (entrainment) valve.
 If multiple users share the same equipment, use low-resistance and
bacteria-filtered cotton between the equipment and the tube.
Note: The selected mask, breathing tube shall meet the performance
requirements with good stability. The user should check the mask and tube for
damage before each use.
 If necessary, place a bacterial filter in the air outlet of the unit and connect the tube.
The use of bacterial filter cotton may affect the equipment work. However, the
device can remain functional and be treated.
 Never place the respiration hose around the neck.
 Do not use any small parts to fix the respiration hose in position as they might be
accidentally swallowed.
 Do not squash the respiration hose.