User's Manual

RXiBreeze PAP System User Manual
4
 Please first check the breathing tube is connected correctly to avoid strangulation
risk due to breathing tube and hoses when used.
 Do not pull or stretch the tubing. This could result in circuit leaks.
 If the device is used by multiple persons (such as rental devices), a low-resistance,
main flow bacteria filter should be installed in-line between the device and the circuit
tubing to prevent contamination.
 Allow the humidifier heater plate and water to cool down for approximately 15
minutes before removing the water tank. A burn may result from: touching the heater
plate, coming in contact with the heated water, or touching the tank pan.
.
CAUTION:
 Medical electrical equipment needs special precautions regarding EMC and needs
to be installed according to EMC information, Contact your home care provider
regarding EMC installation information.
 Mobile RF communications equipment can affect medical electrical equipment.
 Pins of connectors marked with the ESD warning symbol shall not be touched and
connections shall not be made without special precautions. Precautionary
procedures include methods to prevent build-up of electrostatic charge (e.g., air
conditioning, humidification, conductive floor coverings, non-synthetic clothing),
discharging one’s body to the frame of the equipment or system or to earth. It is
recommended that all individuals that will handle this device understand these
precautionary procedures at a minimum as part of their training.
 Condensation may damage the device. If this device has been exposed to either
very hot or very cold temperatures, allow it to adjust to room temperature (operating
temperature) before starting therapy. Do not operate the device outside of the
operating temperature range shown in the Specifications.
 Do not use extension cords with this device.
 Make sure the filter area on the side of the device is not blocked by bedding,
curtains, or other items. Air must flow freely around the device for the system to
work properly.
 Make sure the gas intake port on the side of the device is not blocked by bedding,
curtains, or other items. Air must flow freely around the device for the system to
work properly.
 Do not place the device directly onto carpet, fabric, or other flammable materials.
 Do not place the device in or on any container that can collect or hold water.
 A properly installed, undamaged filter is required for proper operation.
 Tobacco smoke may cause tar build-up within the device, which may result in the
device malfunctioning.
 Dirty inlet filters may cause high operating temperatures that may affect device
performance. Regularly examine the inlet filters as needed for integrity and
cleanliness.
 Always ensure that the DC power cord securely fits into your therapy device prior to
use. Contact your home care provider or Resvent to determine if you have the
appropriate DC cord for your specific therapy device.
 When DC power is obtained from a vehicle battery, the device should not be used
while the vehicle’s engine is running. Damage to the device may occur.
 Only use a Resvent DC Power Cord and Battery Adapter Cable. Use of any other
system may cause damage to the device.
 When change the pressure setting, please consult your doctor.
 Do not position next to a curtain that blocks the flow of cooling air, thereby causing
the equipment to overheat.