User's Manual

Operating Instructions

1. Notes

1.1. All the pagers should be placed in the charging slot before the operation, and be set up after

charging for 20 minutes.

1.2. Power on: Place all receivers in the charging slots. After the keyboard transmitter is powered on,

the pagers will automatically turn on.

1.3. Power off: Place all the paired pagers in the charging slots. Enter “999” by the keyboard transmitter

and then press the [Call] button.

1.4. Enter the setting mode: Press the [Call] button and the [Clear] button at the same time until the

transmitter displays [F1], then enter the mode selection interface. At this time, input the corresponding

number “1-4” by the keyboard to choose the function settings, and press the [Call] button to enter the

setting mode. After setting, press [Clear] to exit the setting mode, and the standby screen will display “---”.

1.4.1. Enter the number "1": [F1] Keyboard Transmitter ID setting

1.4.2. Enter the number "2": [F2] Pager ID setting

1.4.3. Enter the number "3": [F3] prompt mode setting

1.4.4. Enter the number "4": [F4] prompt duration setting

Operation process: First to set the Keyboard ID [F1], then set the prompt mode [F3], then set prompt

duration [F4].

After completing the above settings, finally set the pager ID [F2].

2. 【F1】Keyboard Transmitter ID Setting

Enter the setting mode, the current keyboard transmitter ID flashes on the display.Enter the new ID

number “001-999” by the keyboard, then press the [Call] button to save.

Note: If there is no special requirement, please do not modify the keyboard transmitter ID. Otherwise,

all the pagers need to be repaired to the transmitter.

In addition, do not set the keyboard transmitter ID to “000”.

3. 【F2】Pager ID Setting

3.1. Firstly, remove all the pagers from the charging slots, then enter the pager ID setting mode 【F2】,

the "001" will flashes on the display. Input the new ID number “1-998” by the keyboard. Then put the

pager that need to be set into the charging slot, the pager’s indicator light flashes, it means to be set

successfully.

Then remove the pager from the charging slot, and set the other pagers in turn, press [Clear] button to

exit after all pagers ID settings are completed.

3.2. Do not set "999" as the pager ID, since this ID is the default set to turn off all of the pagers.

3.3. To modify the pager ID, just set a new ID, it will automatically overwrite the old one.

4.【F3】Prompt Mode Setting

Enter the prompt mode setting 【F3】, the default screen flashes “001”, enter number “0 (buzzer beep

off)/1 (buzzer beep on)” from the keyboard, press the [Call] button to save.

5.【F4】Prompt duration setting

Enter the prompt duration setting mode, the default screen flashes “001”,then enter the number “1-999”

from the keyboard, press the [Call] button to save. The unit is seconds.