Technical data

Settings
7
Redialling .............................. Every 5 to 60 seconds. Here, you can define the pause to be made between the individual dialling
attempts during the automatic redialling process.
Call-back code ...................... Here, you enter the call-back code of your telecommunications provider (eg H*37#). The “H”
stands for the hook flash-function. Up to 6 digits are at your disposal for entries.
Telephone systems .............. >>
Exchange
identification code .... Here, you enter the identification code to access the public exchange (e. g. 0). This number will
then always be dialled automatically before the telephone number apart from cases where a tele-
phone number is marked by “i” which stands for an internal extension of the telephone system.
Internal call-back
code ............................ Here, you can enter the call-back code of your telephone system (e. g. 79). Up to 6 digits are
available for your entry.
Dialling mode ............ DTMF (dual tone multi frequency also known as tone dialling) or the pulse dialling method. If your
telephone access does not support the customary tone dialling method yet, you have the option to
switch to the old pulse dialling method.
Special information tone ..... You can either set the information tone volume to level 1 to 4 or you can set it OFF. If you activate
the information tone by setting the volume, a new incoming message will be indicated by an in-
formation tone given every 10 seconds.
Display light .......................... Automatically or ON. As for the parameter “automatically”, the display will no longer be lit after 10
seconds. Shall the display be lit permanently, select “ON” here.