Data Sheet

www.antex.co.uk
22
22
22
22
Only Antex bits should be used on
Antex soldering irons. They have been
specifi cally designed to match the power
output of the heating elements. Never
apply power to an iron without a bit fi tted.
Antex replacement bits are manufactured
from high grade copper, plated fi rst with
iron and then nickel to give a longer
working life. Never fi le an Antex bit as this
will reduce the working life.
• When replacing an Antex bit, fi rst
switch off the iron, then attach the
new bit.
• Switch on the power and apply solder
to the bit as it heats up for the fi rst
time.
• When you have fi nished using the
soldering iron, always place the iron in
a safety stand. (ST4 or ST6A)
• Leave a little residue of solder on the
bit. This will reduce oxidisation of the
tip and ensure a longer bit life.
• Wipe the bit on a clean damp
sponge and apply fresh solder before
re-use.
REPLACEMENT BITS FOR ANTEX PRECISION RANGE
Ref Profi le Tip
ø mm Use On
10 0.5 M, C & TC25
102 2.3 M, C & TC25
103 4.0 M, C & TC25
104 4.7 M, C & TC25
106 1.0 M, C & TC25
107 0.12 M, C & TC25
202 2.3 M, C & TC25
302 2.3 M, C & TC25
820 2.3 M, C & TC25
821 3.0 M, C & TC25
822 4.7 M, C & TC25
1100 2.3 CS, TCS & TC50
1101 3.0 CS, TCS & TC50
1102 4.7 CS, TCS & TC50
1103 6.0 CS, TCS & TC50
1105 0.5 CS, TCS & TC50
1106 1.0 CS, TCS & TC50
1107 0.12 CS, TCS & TC50
1108 3.0 CS, TCS & TC50
1109 5.0 CS, TCS & TC50
50 2.3 XS
51 3.0 XS
52 4.7 XS
53 2.3 XS
54 3.0 XS
55 0.5 XS
56 1.0 XS
57 0.12 XS
50 2.3 XS
51 3.0 XS
52 4.7 XS
53 2.3 XS
54 3.0 XS
55 0.5 XS
56 1.0 XS
57 0.12 XS