Installation Manual

STEP 2: Insert mounting cleats
Check the part shown here, this model has different requirements than the standard parts.
STEP 1: Install front rail gasket
STEP 4: Bolt rails to pickup bed rails
STEP 3: Lift assembled cover into bed and position the rails


 





 
FOR STEP 7 IN STANDARD INSTRUCTIONS:









Rail spacer block
Tailgate
Protector
Tailgate


1/8”
gap
Move the rails to achieve the 1/8” gap
using the 1/8” part at the top of the
bracket. Make certain the rails do not
move after measuring.



  
  
Follow standard instructions
through step 3, (pg. 2) then
refer back to this
guide on how to install
mounting hardware.
A
B
C
STEP 2: Insert mounting cleats
Check the part shown here, this model has different requirements than the standard parts.
STEP 1: Install front rail gasket
STEP 4: Bolt rails to pickup bed rails
STEP 3: Lift assembled cover into bed and position the rails


 
 





FOR STEP 7 IN STANDARD INSTRUCTIONS:



 


 


Rail spacer block
Tailgate
Protector
Tailgate
 

1/8”
gap
Move the rails to achieve the 1/8” gap
using the 1/8” part at the top of the
bracket. Make certain the rails do not
move after measuring.



 
 
Follow standard instructions
through step 3, (pg. 2) then
refer back to this
guide on how to install
mounting hardware.
A
B
C
Continue with the standard
instructions at step 6 (pg. 4)
20
Toyota Tacoma 2005 -2015 Installation