Installation Manual

STEP 1: Install seal
STEP 2: Insert mounting cleats





 
STEP 3: Bolt spacers to RETRAX rails
 
 

5’ model
¼-28 x 0.75L fastener
1/4 flat washer
Cleat
Passenger side rail
6’ model
White plastic
¼-28 x 1.5 L fastener
Cleat
1/4 flat washer
Passenger side rail
STEP 1: Install seal
STEP 2: Insert mounting cleats





 
STEP 3: Bolt spacers to RETRAX rails
 
 

5’ model
¼-28 x 0.75L fastener
1/4 flat washer
Cleat
Passenger side rail
6’ model
White plastic
¼-28 x 1.5 L fastener
Cleat
1/4 flat washer
Passenger side rail
FOR BOTH
MODELS:
TOOLS NEEDED:TO
T-30 Torx driver, 3/8” drive
short extension, ratchet
1 Remove factory cab header rail
2 Use T-30 Torx driver to remove
5 fasteners securing header rail to
front bulkhead below cab rear window
3 Peel backing paper off of foam seal
and adhere to header rail endcaps
4 Reposition factory cab header rail
on truck bed
5 Install and and torque all mounting
bolts to 7.5Nm (66.5 lbs-in)
22
Toyota Tacoma 2016-up Installation