Installation Manual

The 2017 Ridgeline requires a rail mount to be installed before the installation of the RETRAX cover.
Check the parts included in the rail box (shown below).

  
  
  
  
A
B
C
D
The 2017 Ridgeline requires a rail mount to be installed before the installation of the RETRAX cover.
Check the parts included in the rail box (shown below).

  
  
  
  
A
B
C
D
Once the rail kit is installed, continue with the standard instructions for the RETRAX cover on page 2.
Remove the 4 upper tie-down hooks. Keep the 8 Torx bolts, but do not reuse the tie-down hooks.
INSTALLATION INSTRUCTIONS
T50 Torx driver
7/16” Wrench
2017 Honda Ridgeline Mounting Rails
Tools Required:
Front, upper tie-down hooks.
Both sides.
Rear, upper tie-down hooks.
Both sides.
IMPORTANT- INSTALL THESE RAILS FIRST
7
Honda Ridgeline 2017-up Installation