® Standard Series Fuii,-Range Speakers Owner's Manual , .., The information enclosed in this installation guide is to be used as merely an outline to assist you during the process of installation. This guide does not cover every installation possibility, vehicle, or every aspect of the installation process. Retro Manufacturing, LLC, RetroSound~ or its subsidiaries, assume no responsibility for a proper or improper installation.
Standard Speaker Series Manual Thank you for your purchase of this RetroSound® product. Enclosed is some useful information that will maximize performance. If you have any questions about the use or features of this product, email us at: support@retrosound.com or phone us at 702-483-2222. INSTALLATION: The following is a list of tools needed for installation: #2 Phillips screwdriver I Battery post wrench /Hand held drill w/assorted bits/ Wire strippers/Wire crimpers/Wire cutters.
Cfl_t~und_ Standard S eaker Series Manual ~~~~~~:~~~~~~~~= Dual Voice Coil Speaker Wiring Wiring our 4 ohm Dual Voice Coil Speaker for 2 channel connection : Note, the following speaker models from Retrosound (D-52,D-572,D-62 and D-412) feature Dual Voice Coils, this allows you to connect left and right speaker channels to one speaker, this will give you a fuller, richer sound for vehicles that only have one single speaker mounted in the dash or the rear deck area.
Standard Speaker Series Manual Universal Speaker Bracket Kit (UB-1) Available Separately, This 14" bracket combined with the rear threaded mounting point of our new standard series versions of our Dual Voice Coil 5.25", 5x7", 6x9" & 4x1 0" speakers allows you to make your own speaker bracket. You can modify the bracket to solve those challenging installs where there are no other options available. This mounting system is THE answer to classic car speaker installation problems. 0 ¢.
Standard Speaker Series Manual UB-1 Mounting Bracket Configurations Using the UB-1 Bracket: This bracket can be bent in many directions to accomplish the desired results, below are some shapes you can bend the bracket to, which wi_ll help you mount our speaker into your dash. In some cases, you may need two brackets to help mount the speaker to your original dash mount, please review your needs carefully prior to installation. Please email us at support@retrosound.
StandardS ea k~r s=~~s Ma,nygJ Specifications Model Nominal Diameter (inch) Description Nominal Impedance (ohms) Frequency Response Sensitivity (SPL@1w/1m) Power Handling (Watts RMS/Peak) Installation Speaker GrillesMounting Depth (inch) Mounting Depth (mm) Model Nominal Diameter (inch) Description Nominal Impedance (ohms) Frequency Response Sensitivity (SPL@1w/1m) Power Handling (Watts RMS/Peak) Installation Speaker GrillesMounting Depth (inch) Mounting Depth (mm) D-52 5.25" D-62 6.
Limited Warrant If your product does not work properly. because of defects in materials and workmanship RetroSound ®, a division of Retro Manufacturing, LLC (collectNely referred to as "the warrantor") will, for the length of the period indicated in the chart below, which starts with the date of original purchase ("warranty period"), at its option either (a) repair your product with new or refurbished parts, or (b) replace it with a new or refurbished product.