Owner's Manual

10
[e-mail]
Installing the Control Shafts
Step #4
Measure & Set Shaft Width
Parts Needed
B
B
D
C
B Control Shafts x(2)
C Shaft Nuts x(4)
Measure vehicle dash for proper width (shaft hole center to center) and
offset of the shafts (some vehicle shaft locations may be offset from the
radio display). Match the shaft locations from your dash to the proper
InfiniMount Bracket location. Place a Shaft Nut(C) and Shaft Washer(D)
on each shaft about halfway down; the Shaft Nuts will be adjusted in the
next step to set the proper depth.
D Shaft Washers x(4)