Owner's Manual

11
www.retromanufacturing.com
Installing the Control Shafts
Step #5
Set Control Shaft Depth
Adjusting Control Shaft Depth
Insert the Control Shafts into InfiniMount Brackets, add a Shaft Nut(C),
and Shaft Washer(D) to each shaft. To start, bring the shafts forward until
the brass portion is about a quarter-inch past the display face. Adjust
the depth of the shafts as needed by moving the shaft nuts forward or
backward. Once you ensure the shafts are at the proper width and depth,
snug down the shaft nuts to finger tight (DO NOT OVERTIGHTEN). With
the shafts securely in place, plug the shaft cables into the Radio Motor.
D
C
The Control Shafts may need
to be adjusted forwards or
backwards throughout the
installation process to achieve
the perfect depth.