Owner's Manual

16
[e-mail]
Completing the Installation
Step #8
Complete the Installation
Parts Needed
To complete the installation of your radio, add the rear and front knobs to
both Control Shafts.
NOTE: All hardware will not be required for every installation. Extra
items are included to help you get the right fit for your vehicle.
C Shaft Nuts x(2)
D Shaft Washers x(2)
Dashboard
C
D
Faceplate: Once the radio is
supported from the rear and
set into the dash, add your
Faceplate and a final Shaft
Washer(D) and Shaft Nut(C)
to each Control Shaft.
C
Dashboard
D
Bezel: Once the radio is
supported from the rear and
set into the dash with the
Bezel installed, add a final
Shaft Washer(D) and Shaft
Nut(C) to each Control Shaft.