Owner's Manual

2423
www.retromanufacturing.com [e-mail]
RETROSOUND
1 Left-Front Knob
Right-Front Knob 3
2 Left-Rear Knob Right-Rear Knob 4
Apache Radio Controls
Apache Radio Face
Apache Mode (operation without push-buttons)
To set up your radio to function with the Apache Radio Face, press and
hold the Right-Front Knob(3) for three seconds to access the sub-menu
system. Rotate the Right-Front Knob(3) to cycle through the choices until
SEL PANEL appears. Press and release the Right-Front Knob(3) to select
between APACHE and NORMAL. With APACHE displayed on the screen,
let the unit time out to set.
Storing Radio Presets
To store a preset on the Apache Radio Face, rotate the Right-Front
Knob(3) to tune to the desired station, then rotate the Right-Rear Knob(4)
clockwise to select the desired preset (1-6). Once selected, press the
Right-Front Knob(3) to store.
Recalling Radio Presets
To recall a preset, turn the Right-Rear Knob(4) clockwise and release.
Repeat to move through the saved presets.
USB Device Playback (Motor 2A, Motor 2DAB, and Motor 4HD only)
After connecting a USB device, the radio will display the USB icon
on the screen and automatically find your songs and begin playback.
The Left-Front Knob(1) will enable you to listen to 10 seconds of each
song (INTRO), randomly shuffle all songs (SHUFFLE), and turn on repeat
(REP ALL/REP ONE).
To activate/deactivate INTRO, press and release the Left-Front Knob(1)
until INTRO appears on the screen, rotate Left-Front Knob(1) to toggle
INTRO ON or INTRO OFF. Let the unit time out to set.
To activate/deactivate SHUFFLE/REP, press and release the Left-Front
Knob(1) until SHUFFLE appears on the screen, rotate Left-Front Knob(1)
to select REP ALL/SHUFFLE/REP ONE. Let the unit time out to set.
To go to the next folder, rotate the Right-Rear Knob(4) clockwise.
To go to a previous folder, rotate the Right-Rear Knob(4) counter-clockwise.
Apache Radio Instructions
Troubleshooting
Problem Possible Cause Action to Solve Problem
Radio will
not turn on
(no lights,
no sound)
Constant +12V
(yellow) wire not
connected or incor-
rect voltage
Check all connections for
proper voltage with a volt
meter. Voltage range: 12-
15 volts
+12V ignition/ac-
cessory (red) wire
not connected or
incorrect voltage
Check +12V
accessory (red) wire
connection and test
voltage
Ground (black) wire
not connected
Check ground
connection
Fuse on constant
+12V (yellow) wire
is blown
Replace blown fuse
No sound
heard from
unit but unit
lights up
Volume turned
all the way down
Increase radio volume
Internal amp in
protection mode
Check speaker leads
for any grounded or
shorted wires or reset sys-
tem to factory defaults*
Wrong source mode
selected
Make sure the unit is in
the desired source mode
(RADIO,AUX)
Unit blows
fuses
Possible short in
wiring or incorrect
fuse used
Make sure only fuses with
correct 15 amp ratings are
used and check all wiring
connections for possible
short
Battery hooked up
backwards
Make sure battery is prop-
erly connected
*System Reset
To restore/reset the unit to factory defaults see page 13.