Owner's Manual

STEP 1: Install the Radio Face

Plug the ribbon cable included with the Motor 4 radio body

into the radio face. After plugging in the radio face, attach

it to the radio body (if it is not already attached) and tighten

with the four radio face mounting screws provided in the

radio face box (the screws are very small and are included

in the hardware kit included with your Motor 4 box).

The RetroSound

logo on the Motor 4 radio body should be facing

upwards. Take care to not install the face to the body upside down.

NOTE: Optionally, the radio face can be mounted remotely up to nine feet away

from the Motor 4 radio body using an optional Face to Body Extension Cable (sold

separately). In some installation applications, a bracket (not included) can be used

to mount the radio face to the radio body at an angle.

INSTALLATION INSTRUCTIONS

Figure 1 - Attach the Radio Face

Radio Face

Motor 4

Radio Body