Owner's Manual

INSTALLATION INSTRUCTIONS

STEP 3: Mount Shafts to Brackets

To match the the location of your shafts to the proper width of your

vehicle’s dash, measure the distance between your existing shaft

holes from center to center.

Mount a shaft to each bracket using the supplied shaft nuts

and washers. Finger tighten the shaft nuts to prepare for the nal

installation (see Figure 3). Once you ensure the proper width, snug

down the screws and nuts (DO NOT OVERTIGHTEN).

DO NOT OVERTIGHTEN. OVERTIGHTENING THE SHAFT NUTS WILL DAMAGE THE SHAFTS.

DAMAGE FROM OVERTIGHTENING WILL VOID YOUR WARRANTY.

Finally, plug the shafts into each side of the main unit (see Figure 4).

Figure 3 - Mount Shafts to Brackets

Shaft Washers

Shaft Nuts

Figure 4 - Plug Shafts into the Body