Owner's Manual

NOTE: This unit requires +12 volts to both the red and yellow wires to operate properly.

Locate the three wiring harnesses: main wiring harness, power

wiring harness and speaker wiring harness (see “What’s in the Box”

on page 4). First connect the main wiring harness to the back of

the radio body. Then connect both the power and speaker wiring

harnesses to the black female plug of the main wiring harness.

Next, connect the bare wire ends of your power and speaker wires

to the appropriate power and speaker locations in your vehicle

(see Figure 5). Have your radio installed by a professional if this part

of the install is too difcult, or contact us if you have questions.

Bluetooth

Microphone

Your Bluetooth

microphone enables you to place hands-free

phone calls through your radio. The Bluetooth

microphone input

is located at the rear of the radio body. To use your Bluetooth

microphone, you will need plug it into the plug at the rear of the

radio body and route it to an accessible location such as the

A-pillar or the steering column.

Rear Auxiliary (AUX) Inputs

Two auxiliary inputs are located at the rear of the radio

body. These auxiliary inputs allow you to listen to any external

source with a standard headphone output. An example of

an external source would be a MP3 player, iPod

or iPhone

portable CD player or portable satellite radio receiver.

NOTE:

If the auxiliary cables provided are not long enough, you may use our USB/AUX

Extension Cable (sold separately) to extend the reach of one cable. This cable also allows

the installation of one USB and auxiliary port into the factory location of the cigarette

lighter for a factory look and easy access. A male to male 3.5mm auxiliary cable is

required to connect your device to the auxiliary port on your radio.

INSTALLATION INSTRUCTIONS